DRESSTA Co. Ltd. 560C99/1E — 4.18.1. BOOM CONTROL LEVER POSITIONS

SECTION 4 OPERATING Page 34 PARKING THE MACHINE Avoid parking on a slope, however, if parking on a hillside is necessary, park at the right angle to the slope of the hill and block the tires as shown in Fig. 4.24. ATTENTION: Avoid parking the machine in puddles of oil, grease or gasoline because this damages the tires. Fig. 4.24. Hillside Parking ATTENTION: Park the machine on level ground to obtain accurate coolant, lubricant, hydraulic, fuel level checks. 4.18. LOADER OPERATIONS Loader equipment is hydraulically operated. When the bucket circuit is being operated, oil flow to the boom is cut off. 4.18.1. BOOM CONTROL LEVER POSITIONS (FIGURE 4.25.) Fig. 4.25. Boom Control Lever Positions A.

Raise B. Hold C. Lower D. Float IMPORTANT: Holding the control lever in any position except B "hold" and D “float" for an extended period of time after the hydraulic cylinder rod has reached the limit of its travel will produce excessive heat in the hydraulic system which may affect loader performance. The boom control is located to the far right of the operator's seat. It has four positions: A, B, C, D (“raise", "hold","lower", and "float") OM560C99/1E DRESSTA