MAINTENANCE SECTION 5 Page 3 5.1. GENERAL PRECAUTIONS WORK SAFELY - FOLLOW THESE RULES WARNING!: This symbol and text with bold letters is used throughout this manual to call your attention to instructions concerning personal safety. Observe and follow these instructions. Be certain anyone operating and servicing this machine is aware of these rules. Failure to follow these rules may result in injury or death. A CAREFUL OPERATOR IS THE BEST INSURANCE AGAINST AN ACCIDENT The procedures in this section contain many notes and precautions which should be followed along with standard safety procedures to minimize the possibility of personal injury or improper service.
Improper service could compromise the machine's safety or cause it to function improperly, which could result in personal injury or death. Review the precautions listed in Section 2 "SAFETY PRECAUTIONS." Do not attempt to do repairs you do not understand. Use your "Service Manual" or consult your Authorized Distributor for information. Do not jump on or off the machine. When working under the machine, turn off the electrical system master switch, apply parking brake and tag controls to warn against starting the machine. When servicing in the area of the engine fan or belts, take care to prevent accidental cranking of the engine.
Turn off and lock the electrical master switch and tag the machine. It is not possible to anticipate all conceivable ways or conditions under which this machine may be serviced or to provide precaution for all the possible hazards that may result. Safety is always the most important rule. Constantly be aware of dangers involved in working on the machine and take proper precautions. Standard and accepted safety precautions and equipment should be used. This machine is assembled using high strength fasteners. Do not substitute. Replacement fasteners must be of the same size and strength as the originals (refer to Section 6 SPECIFICATIONS).
Tighten fasteners to the proper torque value specified in Section 6 SPECIFICATIONS, unless otherwise specified. Refer to Spare Parts Catalog of respective model for all replacement parts. Use safety goggles, hard hats, safety shoes, heavy duty gloves and other protection during cutting, grinding, chiseling, prying or any other process which could cause material removal or projectiles. Many machined parts are hardened and can chip. Use the proper size and type of tool for the job being done. Select a wrench that fits and be sure it is on straight. Keep your tools clean and in good condition. Some procedures require the use of tools specially designed for that specific purpose.
Before substituting another tool or procedure, you must be completely satisfied that neither personal safety nor the performance of the machine will be endangered. Scheduled maintenance is a normal procedure necessary to provide machine’s proper operation. WARNING! For your personal safety carry out all maintenance service in accordance with specified scheduled maintenance guide and instructions. To prolong the service life of your equipment follow the scheduled maintenance listed in 5.2. and 5.3. DRESSTA OM560C99/1E