BAIC — GPRS Services

Home Location Register (HLR) Release 9.1 Subscriber Provisioning Reference Manual Attributes and Values Table 73: GprsContext mandatory attributes Table 74: GprsContext optional attributes 156 910-6701-001 Revision A, June 2013 Attribute Value Range Default Description PdpContextId 1 to 50 N/A Index of the PDP context. Each Imsi can have up to 50 PDP contexts. AccessPointName up to 63 digits and/or letters N/A A label according to DNS naming conventions describing the access point to the external packet data network.

Access Point Name (APN) in the HLR contains either only an APN Network Identifier (i.e., an APN without APN Operator Identifier) or the wild card value (indicates that the user may select an APN that is not stored in the HLR). Note: Do not use the following characters in the AccessPointName: , :, ;, &, >, Attribute Value Range Default Description PdpType 0 (X25), 1 (PPP), 2 (OspIhoss), 33 (IPv4), 87 (IPv6) 87 (IPv6) PDP Type indicates which type of protocol is used by the MS for a certain service. PdpAddress up to 127 digits and/or letters (including the character “.” ) N/A PDP Address holds the address of the MS for a certain service, i.e., an IP or X.121 address.

If dynamic addressing is allowed, PDP Address is empty in the HLR. VplmnAddress- Allowed 0 or 1 0 VPLMN Address Allowed specifies whether the MS is allowed to use a dynamic address allocated in any VPLMN. 0 = not allowed 1 = allowed QosDelayClass 1 (DelayClass1), 2 (DelayClass2), 3 (DelayClass3), 4 The delay incurred in end-to-end transmission of Service Data Units through the GPRS networks.