PACCAR 567 — Engine Block Heater (Option)

DRIVING - Starting and Warming Up 3. Disengage (depress) the clutch (with manual transmission). 4. Turn the ignition switch to START. 7. Slowly engage (release) the clutch after the engine has started. 8. Wait for the oil pressure gauge to reach normal operating pressure before operating the vehicle or idling faster than 1,000 rpm. DO NOT start the engine with the heater plugged in. WARNING NOTE Engine block heaters can cause fires which may result in property damage, personal injury, or death if not properly maintained and operated. Regularly in- spect the engine block heater wiring and connector for damaged or frayed wires. DO NOT use the heater if there are any signs of problems.

Contact your authorized dealer or the manufac- turer of the heater if you are in need of repairs or information. If Anti-Theft is enabled, you will need to enter the Passcode in order to start the engine (see Anti-Theft). Tips to Remember When Starting Vehicle in Cold Weather If you follow a few simple guidelines, you will extend the service life of your engine: Keep the electrical system in top condition. Use the best quality fuel of the recommended grade. Use recommended engine lubricating oil. For manual transmissions and auxiliary transmissions, leave the transmission in neutral and allow the transmission lubricating oil to warm up (approximately 3-5 minutes) before operating vehicle.

4 5. If the engine does not start within 30 seconds, release the ignition switch. To avoid overtaxing the starter motor or the batteries, don’t use the starter for more than 30 seconds. Let the starter motor cool and the batteries recover for two minutes before trying again. If the engine still won’t start after a couple of tries, check the fuel lines for possible fuel starvation or air leaks. Starting failure may mean fuel is not reaching the injectors. 6. As soon as the engine starts, begin to watch the oil pressure gauge. Check your engine manufacturer’s manual for the right pressure for your engine. If the oil pressure doesn’t rise within a few seconds, stop the engine.

Find out what is wrong before restarting the engine. CAUTION Always unplug heater before starting the engine. Damage to the cooling system could occur if the heater is not turned OFF (unplugged). Engine Block Heater (Option) To preheat the engine before starting, plug the optional engine block heater into a properly grounded AC electrical source. Depending on engine make, when the temperature falls below -10°F (-24°C), the block heater is required. 132 Y53-6126-1A1 (01/21)