DRIVING - Brakes Clutch Abuse Protection The clutch can overheat and slip with improper use.Select the lowest possible start gear for the application. If moving slowly is required, select 1st or R1. Use the Service Brake and let Hill Start Aid assist you when launching on an incline. Do NOT use the throttle to hold the vehicle on an incline. (Use Service Brake). Do NOT use the throttle to stop roll back on an incline after Hill Start Aid disengages. (Use Service Brake and then relaunch). Automatic Transmissions An automatic transmission makes shifting much easier. It remains important to completely understand how to operate the transmission to optimize its efficiency.
Please read the manual for your automatic transmission included with your vehicle. Brakes Air Brake System WARNING WARNING DO NOT drive through water deep enough to wet brake components, as it may cause the brakes to work less ef- ficiently than normal. The vehicle's stopping distance may be longer than expected, and the vehicle may pull to the left or right when brakes are ap- plied, which could contribute to an ac- cident involving death or personal in- jury. 4 DO NOT leave the cab of your vehicle without applying the parking brake. The truck could roll and cause an acci- dent resulting in death or personal in- jury. Always apply the parking brake before you leave the cab.
Gear Display Icon (Clutch Abuse) If the clutch does start to overheat, the display will show “CA” along with a warning tone. Full clutch actuation must be completed quickly. If not, the system will either open the clutch if not on the throttle or close the clutch if on the throttle. If the abuse continues, the system will open the clutch and take away throttle control for a short period of time to allow the clutch to cool down. Auxiliary Transmission If you have an auxiliary transmission, see your transmission manufacturer’s manual for its proper operation.
Compressed air is delivered to the brake system through the valve at the brake pedal and is controlled with various valves and braking circuits. The brake system is designed with separate front, rear, and (when applicable) trailer circuits so that if one circuit is compromised and loses air, the other circuits will not be affected. Safety valves in each circuit will protect the other circuits in the event that a circuit loses air. Y53-6126-1A1 (01/21) 159