PACCAR 567 — How to Operate Two-Speed Axle - High to Low

DRIVING - Axle and Suspension axle, and wheels adjust, allowing for proper gear engagement. When going downhill the wheels will not slow down, but will tend to speed up, which makes gear synchronization almost impossible. As a result, the axle is neither in HIGH nor LOW range and all engine/ driveline retardation is lost. Without engine retardation it is more difficult to slow the vehicle down and greater stress is put on the brake system. 1. Be sure the differential is UNLOCKED. 2. Maintain your vehicle speed (accelerator depressed) and move the Range Selector lever to HIGH. 3. Keep driving with the accelerator depressed until you want the axle to shift. 4.

To make the axle shift, release the accelerator until the axle shifts. You are now in the HIGH axle range for highway speeds. Shift the transmission normally to reach your desired cruising speed. WARNING Never shift the axle when moving downhill. Engine driveline disengage- ment may occur, eliminating engine re- tardation and allowing the wheels to spin faster than the current speed of the engine. This may require severe braking to slow the vehicle down and can result in an accident. Failure to comply may result in death, personal injury, equipment or property damage.

4 CAUTION To avoid damaging your vehicle shift the axle at slower travel speeds until you are used to driving with a dual range axle. CAUTION How to Operate Two-Speed Axle - High to Low These steps should be used if operating a two-speed axle in HIGH range on improved roads and preparing to drive on rough terrain. When you go from highway driving to rough terrain, shift the axle to the LOW range following this procedure: 1. Maintain vehicle speed (accelerator depressed) and move the Range Selector lever to LOW. 2. Keep driving with the accelerator depressed until you want the axle to downshift.

If you shift the axle range with the in- ter-axle differential in LOCK, you could seriously damage the axles. Never shift the axle range with the differential locked. How to Operate Two-Speed Axle - Low to High These steps should be used if operating a two-speed axle in LOW range on rough terrain and preparing to drive on an improved surface. When you go from rough terrain to highway driving, shift the axle to the HIGH range following this procedure: Proper shifting of the axle depends on the synchronization of engine/driveline and wheel speed. When you shift the axle, the connection between the engine and wheels is momentarily disengaged while the gearing is synchronized.

Normally when the axle is shifted the speed of the engine, Y53-6126-1A1 (01/21) 171