DRIVING - Axle and Suspension Maximum tire static loaded radius (SLR) per axle manufacturers specifications Setting the Pressure-to- Load Ratio To obtain the desired axle load distribution, you must correlate the suspension air gauge pressure to the actual axle load by scaling the axle weight(s) and adjusting the pressure to obtain the desired load. Once the desired load or load range is achieved, document the pressure-to-load ratio or setting for future use. CAUTION DO NOT modify the air system and/or control functionality on a factory instal- led auxiliary axle(s). Modifying the fac- tory operation of the pusher and/or tag axle(s) will void your warranty, and can cause equipment damage.
Pusher or Tag Suspension Calibration Perform this procedure at or near a weight scale. Procedure can be performed while parked on the weight scale if scale is available. To obtain the desired axle load distribution, you must correlate the suspension air gauge pressure to the actual axle load by scaling the axle weight(s) and adjusting the pressure to obtain the desired load. Once the desired load or load range is achieved, document the pressure-to-load ratio or setting for future use. These instructions are general in nature. For more specific instructions, review the pusher or tag suspension manufacturers maintenance manual or contact the nearest authorized dealer. 1.
Park the loaded vehicle on a level surface with the wheels blocked. 2. Release vehicles spring brakes. (Do not release for Liftable/Non- Steerable pusher or tag axles) 3. Lower the pusher/tag axles with the Axle Lift Control flip valve. (For some non-liftable axles, inflate air suspension) 4. Adjust the amount of load on each axle by turning the Pressure Regulator clockwise to increase the load, or counterclockwise to decrease the load. (The suspension manufacturer may publish pre-established Pressure- to-Load Ratio Pressure Settings to 4 CAUTION A change in tire size on either the aux- iliary axles or the drive/steer axles can change the calibration of the auxiliary axles.
If tires are installed with a differ- ent loaded radius, the calibration pro- cedure must be repeated. Failure to do so can cause equipment damage. NOTE Contact your dealer or axle manufacturer to determine what the creep rating is for your particular axle(s) and configuration. Creep ratings are generally limited to the following: Tandem rear axles only Straight trucks only Maximum spring mount centers per axle manufacturers specifications This procedure must be performed pri- or to placing the vehicle into service. Add: Perform this procedure at or near a weight scale. Procedure can be performed while parked on the weight scale if scale is available. 174 Y53-6126-1A1 (01/21)