PACCAR 567 — Air Ride Height Data

DRIVING - Axle and Suspension 6. Rotate the valve either clockwise or counterclockwise until air pressure in the air springs provides the ride height specified for that suspension. Measure the ride height from the bottom of the frame rail to the approximate centerline of the rearmost drive axle hub: For tandem axles, make the vertical measurement at the centerline of the suspension. For a single axle, make the measurement in front of the axle, in the area forward of the tires but not past the suspension bracket. 7. When at the correct ride height, ensure that the height control valve lever is in the neutral position, then install either the built-in alignment pin or a 1/8 in. (3 mm) dowel.

8. Torque the mounting fasteners to 55-75 lb-in. (6.2-8.5 N·m). 9. Remove the alignment pin or dowel. 10. Repeat Steps 2 through 6 above for the right-hand valve on vehicles with a dual-valve system. Air Ride Height Data These are factory settings for ride height of the rear air suspension. 4 1. Ride height 2. Centerline of suspension 176 Y53-6126-1A1 (01/21) Single Axle Unladen Ride Height -in. (mm) Air Trac 11.39 (289) Low Air Leaf 6.75 (171) Tandem Axle Laden Ride Height - in. (mm) Air Leaf 11.70 (297) Air Trac 11.00 (279) Low Air Leaf 8.50 (216) Low Low Air Leaf 6.50 (165) FLEX Air 8.50 (216) Tandem Axle Unladen Ride Height -in.

(mm) Air Leaf 12.0 (305) Air Trac 11.38 (289) Low Air Leaf 8.75 (222) Low Low Air Leaf 6.75 (171) FLEX Air 8.75 (222) Single Axle Laden Ride Height -in. (mm) Air Trac 11.00 (279) Low Air Leaf 6.50 (165)