MAINTENANCE - Every 120,000 mi / 192,000 km / Annually Rear Suspension - Mounting Brackets and Fasteners Check the condition and the fastener torque. Tighten to the specified torque value as required.(Refer to Suspension U-Bolts, Grade 8 on page 306 for maintenance instructions.) Every 120,000 mi / 192,000 km / Annually 13 Hub, Drum, and Hubcap - Hubs (non-LMS) with Standard Seals Clean the components and check for excessive wear or damage. Change the oil and seal. (Refer to Wheels on page 294 for maintenance instructions.) Cooling - Extended Life Coolant (ELC) Perform lab analysis. If lab analysis shows coolant is unsuitable for continued use: Flush, drain, and refill. Add ELC Extender.
(Refer to Cooling System Maintenance on page 250 for maintenance instructions.) 5 Power Steering - Reservoir (ON HIGHWAY) Drain, replace the filter, and refill. (Refer to Check Power Steering Fluid Level on page 289 for maintenance instructions.) Steering Components - Steering Linkage Check all joints for excessive lash: replace as required. (Refer to Steering System on page 288 for maintenance instructions.) Fuel and Tanks - Fuel Tank Breathers Check for proper function: clean the drain hoses.
(Refer to Fuel Tank on page 273 for maintenance instructions.) Driveshafts - Models SPL-140XL/ 170XL/250XL Slip Members and U- joints (OFF HIGHWAY and CITY) Lubricate Cab Structure, Doors and Hoods - Body and Cab Hold down Bolts, Cab Structure, Doors and Hoods on page 247 13 Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of those listed here. * Use only Spicer Driveshaft approved lubricants when greasing Spicer U-joints. 226 Y53-6126-1A1 (01/21)