PACCAR 567 — How to Add Coolant to the Cooling System

MAINTENANCE - Cooling System Maintenance Deterioration/signs of leaking Hose clamp torque 1. Turn off the engine and let it cool for a minimum of 10 minutes. 2. If your cooling system is built with an air bleed valve in the upper engine coolant pipe, open the air bleed valve before filling the surge tank. 3. Close any open coolant drain valves in the lower engine coolant pipe. 4. Remove the surge tank fill cap (1). DO NOT remove the surge tank pressure cap (2). 5. Fill the system with premixed coolant through the surge tank fill port. Pour coolant at a steady rate until it reaches the lower of the two lines indicated by either "COLD MIN" or "MIN" on the surge tank.

Wait for one minute after adding coolant. If the coolant level drops, add coolant until it returns to the lower line. 6. Close the air bleed valve if opened earlier in this procedure. 7. Start the engine and maintain an idle at low rpm. 8. While the engine is idling air will purge from the cooling system via the surge tank's coolant fill port, NOTE How to Add Coolant to the Cooling System Use a solution of half ethylene glycol antifreeze and half water for best heater performance. Do not use more than 60 percent concentration of antifreeze, as a shortened heater life will result. DO NOT use the pressure cap to fill the surge tank with fluid. NOTE DO NOT overfill a cooling system.

Ex- cess coolant may result in overflow, loss of antifreeze, and reduced corro- sion protection. WARNING 5 DO NOT remove the coolant fill cap while the engine is hot. Scalding steam and fluid under pressure may escape and cause serious burns. Fail- ure to comply may result in personal injury or death. 1. Radiator Mounted Coolant Surge Tank 3 2 1 Y53-6126-1A1 (01/21) 253 NOTE If frequent topping off is necessary and there are no visible signs of coolant leaks when the engine is cold, check for leaks with the engine operating at normal temperature.