MAINTENANCE - Rear Axle and Suspension type of load, road conditions, and vehicle speed. All vehicles need to have their U- bolts checked and tightened regularly, but severe use of your vehicle can cause them to loosen faster. It is important that U-bolts remain tight. Be sure someone with proper training and the right tools checks and tightens the U-bolts on your vehicle. After the first 500 miles (800 km) of operation, periodically inspect the suspension as noted below:
Visually check for loose or missing fasteners, cracks in hanger, or axle connection brackets Check that springs are centered in hangers and in good condition Check for cracks, wear marks, splits, or other defects on the surface of the spring Replace defective parts. Because repaired springs cannot be fully restored to their original service life, replace the complete assembly if cracks or other defects are detected After replacement of any part or discovery of loose components, check the torque of all fasteners WARNING cause component system failure, pos- sibly resulting in an accident. Improp- erly tightened (loose) suspension U- bolts can lead to unsafe vehicle condi- tions, including:
hard steering, axle misalignment, spring breakage or ab- normal tire wear. Failure to comply may result in death, personal injury, equipment or property damage. DO NOT work on the vehicle without the parking brake set and wheels blocked securely. If the vehicle is not secured to prevent uncontrolled vehi- cle movement, it could roll and may re- sult in death, personal injury, equip- ment or property damage. WARNING CAUTION 5 DO NOT operate the vehicle if the sus- pension U-bolts are not properly tight- ened. Loose U-bolts will cause the axle to not be properly secured to the suspension, which could cause loss of vehicle control and an accident.
Loose U-bolts can also cause uneven tire wear and poor alignment. Failure to comply may result in death, personal injury, equipment or property damage. DO NOT spray the suspension with chemical products or mineral oil; it can cause damage to the bushings. NOTE Failure to follow these recommenda- tions could void warranty. Visual Inspection WARNING For all vehicles, mandatory maintenance procedures include retightening of U-bolts and complete inspection. Even with proper maintenance, however, many factors affect the service life of springs and suspension components:
fatigue, vehicle gross weight, Failure to maintain the specified torque values or to replace worn parts can Y53-6126-1A1 (01/21) 283