PACCAR 567 — Wheels

MAINTENANCE - Wheels Greenhouse Gas Certified Tires be clean and dry. Do not lubricate wheel nuts or studs. for disc brake applications. If it ever becomes necessary to replace an original equipment wheel, the replacement wheel must be the same brand and size as the take-off wheel. On vehicles equipped with 22.5 in. disc wheels, installing the wrong replacement wheel could result in the wheel valve stem making contact with the disc brake assembly. When installing any replacement wheel, always inspect the tires/wheels to ensure there is adequate clearance between other vehicle components. With the hood open, check for clearance between the wheel and disc brake assembly.

Use a hydraulic jack to raise the front of the vehicle off the ground to allow the wheel to spin freely. While rotating the wheel, check to ensure there is adequate clearance between the wheel and disc brake assembly. NOTE WARNING The tires installed on this vehicle at the factory as original equipment are certi- fied for Greenhouse Gas and Fuel Effi- ciency regulations. Replacement tires must be of an equal or larger loaded drive tire size and an equal or lower rolling resistance level (TRRL or Crr). Consult with your tire supplier(s) for appropriate replacement tires.

Never use oil or grease on studs or nuts; improper torque readings will re- sult, which could cause improper wheel clamping and could lead to a wheel failure resulting in an accident. Failure to comply may result in death, personal injury, equipment or property damage. 5 In order to limit the rolling resistance of the tires and optimize fuel economy, the maintenance procedures specified by the tire manufacturer must be followed. Please see Vehicle Emissions Limited Express Warranty for warranty on greenhouse gas certified tires. Wheel Replacement with Disc Brake Option WARNING Use only the wheel brand, size and part number originally installed.

Use of a different wheel brand or size could cause valve stem to interfere with a brake component which could lead to loss of vehicle control. Failure to com- ply may result in death, personal in- jury, equipment or property damage. Wheels After the vehicle travels about 50 to 100 miles (80 to 160 km), wheel mountings seat in and will lose some initial torque. Check hub/wheel mountings after this initial period and retighten. Threads should Vehicles equipped with front disc brakes are fitted with wheels designed specifically 294 Y53-6126-1A1 (01/21)