PACCAR 567 — How to Jump Start a Battery

EMERGENCY - How to Jump Start a Battery 8. Attach one end of a jumper cable to the positive (+) terminal of the discharged (dead) battery. This will have a large red + or P on the battery case, post, or clamp. CAUTION NOTE Vehicles equipped with an Engine Start Module (ESM) should not be jumped using the ESM Starter terminal (S+). Failure to comply may result in arcing or battery damage. Always connect positive (+) to positive (+) and negative (-) to negative (-). 2 NOTE 12. If either vehicle is equipped with battery disconnects, ensure that they are in the ON position. 13. Start the vehicle that has the good battery first.

Let it run for 5 minutes, or If charging a system containing an Engine Start Module (ESM), let it run for 15 minutes. Briefly pressing the Push-to-Test button on the ESM will indicate the ESM's charge state. When the status LED presents a solid green light the ESM is sufficiently charged. 14. Start the vehicle that has the discharged (dead) battery. The engine should start. If the engine fails to start, do not continue to crank the starter. Instead, contact the nearest authorized dealer. If your vehicle is equipped with an En- gine Start Module (ESM), attach the positive (+) cable to the vehicle battery and not the ESM Starter terminal (S+).

See the Maxwell Installation Guide and User Manual for additional infor- mation about LED status conditions, maintenance, and troubleshooting. 1. Remove any jewelry that may come in contact with the battery terminals. 2. Select a jumper cable that is long enough to attach to both vehicles in a way that ensures neither vehicle touches each other. 3. Position the two vehicles together, but do not allow them to touch. 4. Turn OFF all lights, heater, radio, and any other accessory on both vehicles. 5. Set the parking brake. 6. Shift the transmission into park position or neutral for manual transmissions. 7.

If either vehicle is equipped with battery disconnects ensure they are in the OFF position prior to connecting the two vehicles. 9. Attach the other end of the same cable to the positive (+) terminal of the good (booster) battery. 10. Attach the remaining jumper cable FIRST to the negative (-) terminal (black or N) of the good battery. 11. Attach the other end of the negative cable to the negative (-) terminal of the dead battery. Y53-6126-1A1 (01/21) 47