PACCAR 567 — Choosing the Active Driver Profile

CONTROLS - Configure Settings shorter shutdown time, the Engine will shutdown at the shorter timer setting. CAUTION fuel consumption and save you mon- ey. Prolonged periods of idling can result in lower than optimal engine/transmis- sion operating temperatures which could cause increased rates of wear. Do not allow the engine to operate at idle for extended periods at tem- peratures at or below 160F/71C. To help prevent this from occuring on PACCAR engines, an idle shutdown feature can be programmed to shut the engine down after a period of low idle operation with no driver activity. A flashing warning lamp will inform the driver of an impending shutdown.

Fail- ure to comply may result in equipment or property damage. When active, the Shutdown Timer will keep the engine running for a period of time after the ignition switch is placed in the OFF position. This allows the driver to exit the cab while sustaining power to the cab interior. Normally, this would require the key to remain in the ignition, potentially leaving the cab unlocked and accessible. When the timer reaches zero, the engine stops, removing power from certain electrical loads. The timer counts down in the Drive Summary. The Shutdown Timer is enabled or disabled in the Display menu and can be set for up to 30 minutes.

This setting can be changed in the Settings Sub-menu or while counting down, in the Drive Summary, using the Scroll and Select (See How to Set the Shutdown Timer on page 140). The Shutdown Timer setting may be limited to less than 30 minutes (See Greenhouse Gas Certified Configuration). If your truck has the Engine Idle Shutdown Timer (EIST) option and it is set for a Driver Profiles This feature saves customizations made as a Driver Profile. Turning Driver Profiles ON for the first time will load current customizations into Driver Profile 1 and make it the active profile. The profile can be changed in this menu.

The active Driver Profile can also be changed after setting the park brake and then pressing Back . 2 Changes to Driver Profile will be auto-saved while making customizations. They will not be lost when turning the feature off. 3 NOTE The last used active profile, including any changes to that profile, will remain the profile until a new one is selected. NOTE If you are required to idle your vehicle for long periods of time, install an aux- iliary heater or automatic idle control. These auxiliary devices can reduce Choosing the Active Driver Profile Press Back when the parking brake is set to change the active Driver Profile.

2 The ignition key may need to be cycled back to OFF and then ON to access the Driver Profiles Settings. 74 Y53-6126-1A1 (01/21)