. OPERATION TRANSPORTATION LIFTING MACHINE WARNING NOTICE 3 - 183 The ope rator carrying out the lifting oper ation using a c rane mu st be a properly qualified crane o Never r aise the machine w ith any worker Always make sure that the wire rope is of ample strengt h for the weight When li fting, keep the ma chine horizontal When c arrying out lifting o perations, set th e lock lever to the LOC K position to prevent the machine from moving unexpectedly. Never e nter the area unde r or around a ra ised machine. Never try t o lift the machine i n any posture o ther than the p osture g iven in the procedure below or u sing lifting equipment other than in the procedure below.
chine may lose its balance. There is a hazard that the ma chine may lose This meth od of lifting applies to the standar d specification machine The metho d of lifting differs according to the attachments and options For details of the procedure for machines th at are not the standard specification, please consult you r Komatsu distributo For weigh When lifti ng the machine, carry out the operation on flat ground as 1. Start the engine, then the swing the upper struct ure so t hat the work equipment will b e on the side of spr ocket (1). 2. Exten ork equipment to the ground a s shown in th e diagram ght using the bo 3. Set th e lock lever sec urely to the L OCK position 4.
Stop the engine, chec k that there is nothing aro und the operator's compartment, then get off the machin Close the cab door an d front glass securely.