. OPERATION LONG TERM STORAGE LONG TERM STORAGE BEFORE STORAGE machine in the DURING STORAGE WARNING 3 - 188 NOTICE When storing the machine (1 month or more), set the posture shown in the diagram on the right to protect the (To prevent rustin g of the cylinder rod) When putting th e machine in storage for a long tim e (more than one month), do as follows . Clean and wa sh all parts, then store the machine indoors. If the machine has t o be store d outdoors, sele ct level ground and c over the machine with canvas. ture from collecting. er piston rod with grease. Completely fil l the fuel tank. This prevents mois Lubricate and change the oil before storage.
Coat the expo sed portion of the hydraulic cylind Disconnect th e negative terminals of the battery a nd cover it or remove it from th e machine and s tore it sep arately. Lock each co ntrol lever and pedal with the lock lever and pedal lock. Set the stop v alve to the LOCK position on machi nes ready for attachments. In stall the bl ind pl ugs to the elbows. For details o INSTALLATIO f the LOCK and FREE position N (PAGE 6-13)". s of the stop valve, see "ATTACHMENT REMOVAL AND REMOVA To prevent ru st, fill with Komatsu genuine superc oolant (AF-NAC) to give a de nsity of at l east 3 0% for the engine coolant.
If it is necessary to perform the rust-prevention operation while the machine is indoors, op en the door s and windows to improve ventilation and pre vent gas poisoning. During storag e, operate and move the machine fo r a short distance once a mon th so that a new film of oil will coat moving parts. At the same time, also charge the battery. the grease from the hydraulic cylinder rods. When operati ng the work equipment, wipe off all the grease from the hydrauli c cylinder If the machine is equipped with an air conditione r, operate the air conditioner f or 3 to 5 m inute s once a m onth to lubricateall pa check the refr rts of the air conditionercompresso r.
Always run the engine at lo w idle whe n doin g this. In a ddition, igerant level twice a year.