Komatsu — Full page photo print Komatsu

. MAINTENANCE OUTLINE OF SERVICE 4 - 5 FUEL To prevent the moisture in the air from condensi ng and forming water inside the fuel tank, always fill the fuel tank after completing the day's work. uel containing water or dirt is used, it cannot work properly. when storing or adding fuel. re in the Operation and Maintenance Manual. The fuel pump is a precision instrument, and if f Be extremely careful not to let impurities get in Always use the fuel specified for the temperatu If the fuel is used at temperatures lower than t °C (5°F), the fuel will solidify. If the fuel is used at temperatures higher tha result in problems such as a drop in output.

If the fuel is used at temperatures lower than t he specified temperature (particularly at temperatures below -15 If the fuel is used at temperatures higher tha n the specified temperature, the viscosity will drop, and this may Before starting the engine, or when 10 minutes h ave passed after adding fuel, drain the sediment and water from the fuel tank. If the engine runs out of fuel, or if the filters hav e been replaced, it is necessary to bleed the air from the circuit. If there is any foreign material in the fuel tank, w ash the tank and fuel system. NOTICE Always use diesel oil for the fuel.

To ensure good fuel consumption characteristics and ex haust gas characteristics, the engine mounted on this machine uses an electronically controlled high-pressure fuel injection dev ice. This device requires high precision parts and lubrication, so if low viscosity fuel with low lubricating ability is used, the dur ability may drop markedly. COOLANT AND WATER FOR DILUTION nting corrosion as well as preventing freezing. e, the use of antifreeze coolant is essential. Supercoolant (AF-NAC).

Komatsu Supercoolant (AF-NAC) has The coolant has the important function of preve Even in the areas where freezing is not an issu Komatsu machines are supplied with Komatsu excellent anticorrosion, antifreeze and cooling pr opertiesand can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the u se of any coolant other than Komatsu genuine supercoolant (AF-NAC). If you use another coolant, it may ca use serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. d water or tap water (soft water).

ter (hard water), contains large amounts of minerals (calcium, When diluting the antifreeze coolant, use distille Natural water, such as a river water or well wa magnesium, etc.), and this makes it easier for sc ale to form inside the engine or radiator. Once scale is deposited inside the engine or radiator, it is extremely di fficult to remove. It also causes overheating due to poor heat exchange, so when you dilute the coolant, we r ecommend that you use water with an overall hardness of less cautions given in the Operation and Maintenance Manual. eep it away from flame. ffers according to the ambient temperature. N INSIDE OF COOLING SYSTEM (PAGE 4-25)". than 100 PPM.

When using antifreeze, always observe the pre Antifreeze coolant is flammable, so be sure to k The ratio of Supercoolant (AF-NAC) to water di For details of the ratio when mixing, see "CLEA Even in areas where it is not necessary to prev ent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at stem. mix. In this case, never add diluting water. ool before adding coolant. least 30% to prevent corrosion of the cooling sy Supercoolant (AF-NAC) may be supplied in pre If the engine overheats, wait for the engine to c If the coolant level is low, it will cause overheatin g, and will also cause problems with corrosion due to air entering the coolant.