. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 12. Drain the If the sub-tank is extremely dirty and it is difficult to clean, loose, Tightening Track shoe shown in the diagram on the right. nut and shoe are in close contact 4 - 28 sub-tank the then add wate r until the coolant lev el is between the LOW marks. it with a new 13. Stop the e ngine, wait fo r approx. 3 minutes, add city w ate r up e mouth of the filler port, then tighte n radiator cap (1). CHECK AND TIGHTEN TRACK SHOE BOL If the machin e is used with track sh oe bolts (1 break, so tigh ten any loose bolts imm hey will 1.
First tight en to a tightening torque of 490 ± 4 9 Nm (50 ± 5 kgm, 360 ± 36 lbft) then chec k that the nut an d shoe se contact with the link contact surf 2. After chec king, tighten a further 1 Order for Tigh Tighten the b After tightenin g, check that with the link m ating surface