. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE Replace inner seal (3) with a new part. out, then pump it in REMARK It is not necessary to remove the plug at the top of the fuel same procedure to 4 - 67 NOTICE ew filter cartridge with fuel. Do not fill the n Remove cap (B) and install the filter cartridge. 6. When installi ng, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter ca filter cartridg rtridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the e is too loose, fuel will also leak from the packing, so always tighten the c orrect amount. 7.
Turn the valv e (1) at the bottom of the fu el tank to the OPEN position (O). r cartridge (2), bleed the air. 8. After comple ting the replacement of filte Bleed the air as f 9. Fill the fuel ta nk with fuel (to the position 10. Loosen the k nob of feed pump (4), pull the movement becomes he pre-filter and f After the eng pump (4) and bleed the air. 11. Push in the k nob of feed pump (4) and t 12. After replacin g the filter cartridge, start t he engine and run it at low idling for 10 minute Check for lea If there is sti foreign mate it. kage of oil from the filter sea l surface. If any oil is leaking, check the tighten ing of the filter cartridge.
ll oil leakage, repeat Steps 1 - 4 to remove the filter cartridge, and if an y damage or embedded rial in the packing surface is found, replace it with a new cartridge and rep eat Steps 5 - 12 to install REMARK Sometimes som e air is still left inside water s eparator after air bleeding, but the engine can be started by operating feed pump (4) un til its motion gets hard. The remaining air is naturally bled when the wate r separator is left as it is for some time aft er the engine comes to a s top.