. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN HYDRAULIC TANK WARNING cause burns. Wait for the 4 - 80 EVERY 5000 HOURS MA INTENANCE Carry out the periodic mainten ance work of every 100, 250, 500 and 1000 hours of opera The parts and oil are at high temperature immediately after the engine is stopped, and may starting the work. , turn it slowly to release the internal pressure, then remove it. temperature to go down before When removing the oil filler cap NOTICE If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket If hydraulic breaker, the hydraulic oil will operations. For details, see "M maintenance.
AINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out Refill, capacity: 121 liters (3 Prepare a handle (for the so 4. Remove the cap of oil filler port (F) at the top of the hydraulic der the drain plug located on the ch oil that is drained. Remove drain heck an O-ring installed to Plug (P), mage, replace it with new one. After in plug (P). g torque is 68.6 ± 9.81 Nm (7 ± 1 on yourself when you remove drain tank. 5. Set a container direct un machine's underside to cat plug (P) and drain the oil. C and if it has a scratch or da draining the oil, tighten dra The specified tightenin kgm, 50.6 ± 7.2 lbft) Take care not to get oil plug (P). 6.
Add the specified amount o f new and clean oil through oil filler port (F). Check that the oil level is between H and L on the sight gauge. For details of the suitab le oil, see "RECOMMENDED FUEL, COOLANT, AND LUBRICANT (PAGE 4-9)". For details of the metho 3-115)". d of checking the oil level, see "Check Oil Level in Hydrau lic Tank, Add Oil (PAGE aulic circuit. 7. Bleed the air from the hydr For details of the method of SYSTEM (PAGE 4-42)". bleeding the air from the hydraulic circuit, see "BLEEDING AIR FROM HYDRAULIC