. SAFETY PRECAUTIONS FOR OPERATION 2 - 27 PRECAUTIONS WHEN TRAVELING operations, always keep a safe distance from people, structures, or other ontact with them. und, keep the work equipment ve the ground. Otherwise, the the ground and the machine oor, raise the boom to ensure an auto-deceleration system, n switch OFF when traveling on f the machine is operated with , the engine speed will rise and uddenly become faster. when possible. If the machine eep the work equipment close peed. There is more danger of eft or right than tipping over to over obstacles which make the r right sides.
, travel at low speed and do not here is danger that the machine ent may hit the ground surface s balance, or may damage the a. When traveling or carrying out machines to avoid coming into c When traveling on the level gro approximately 40 to 50 cm abo work equipment may contact to may be turned over. If the view to the right side is p better visibility. For machines equipped with always turn the auto-deceleratio rough ground or steep slopes.
I the auto-decelerationsystem ON the machine travel speed may s Avoid traveling over obstacles has to travel over an obstacle, k to the ground and travel at low s the machine tipping over to the l the front or rear, so do not travel machine tilt strongly to the left o When traveling on rough ground operate the steering suddenly. T may turn over. The work equipm and cause the machine to lose it machine or structures in the are When using the machine, to prev ent personal injury caused by damage to t he work e quipm ent or b y the ma chine overturning due to overloading, do not exceed the permitted performance of the machine or the maximum f the machine.
he imum permitted load for the structure o When passing over bridges or st ructures, check first that the structure is st rong enough to suppor t the we ight of the machine. When traveling on public roads, check first with the relevant au thorities and fol low the ir instructions. When operating in tunnels, unde r bridges, under electric wires, or other plac es where the hei ght is li mited, o perate slowly and be extremely careful not to let the machine body or work equip ment hit anythin g.