Komatsu — 24.6.1 CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL

MAINTENANCE 24.5 EVERY 50 HOURS SERVICE 24.5.1 DRAIN WATER, SEDIMENT FROM FUEL TANK Loosen valve (1) on the right side of the tank to drain sediment and water from the bottom of the fuel tank. 24.6 EVERY 100 HOURS SERVICE Maintenance for every 50 hours should be carried out at the same time. 24.6.1 CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING When the oil filler cap is removed, oil may spurt out, so turn OFF the engine and wait for the oil temperature to cool down, then turn the cap slowly to release the internal pressure before removing the cap. If oil level is above the H mark, turn OFF the engine and wait for the hydraulic oil to cool down before draining the excess oil. 1.

Lower the bucket horizontally to the ground and turn OFF the engine. Wait for 5 minutes, then check sight gauge (G). The oil level should be between the H and L marks. NOTE: Do not add oil if the oil is above the H line. This will damage the hydraulic equipment and cause oil to spurt out. 2. If the oil is below the L level, open the inspection cover above the step and add oil through oil filler port (F). 3. If oil has been added to above the H mark, turn OFF the engine and wait for the hydraulic oil to cool down, then drain the excess oil from the drain plug. For specification of the oil to use, see “20.1 PROPER SELECTION OF FUEL, COOLANT AND LUBRICANTS” on page 3-10. 3-45 WA420-3MC