Komatsu — 24.7.1 CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE

MAINTENANCE 24.7 EVERY 250 HOURS SERVICE Also perform maintenance for every 50 and 100 hours. 24.7.1 CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING Wait at least 10 minutes between stopping the engine and changing the oil. The engine needs to cool after running. If the filter is removed before the oil settles the oil might continue to spill. Oil catch container . . . . . . . . . Min 22 Filter wrench . . . . . . . . . . . . . . . . . . . . . . . . 09019-08035 Refill capacity . . . . . . . . . . . . . . . . . . . . . . . . . 19 For oil details, see “20.1 PROPER SELECTION OF FUEL, COOLANT AND LUBRICANTS” on page 3-10. 1.

Warm up the engine to operating temperature and then turn the engine OFF. 2. Open the engine hoods and lock in position. 3. Open oil filler (2) and remove drain plug (3) to drain oil. After draining, tighten the drain plug. 4. Clean the area around the oil filter. 5. Using a filter wrench, remove oil filter cartridge by turning it counterclockwise. 6. Clean the filter gasket surface of the filter header. 7. Fill a new oil filter with engine oil. Then apply engine oil or a thin coat of grease to the seal. 8. Install the filter, threading it into place until its seal surface contacts the sealing surface of the filter base. Then tighten the filter an additional Ѕ to ѕ turn by hand.

Be careful not to tighten it up excessively. Be sure to use a genuine Komatsu filter. 9. After replacing the filter, pour in the specified quantity of engine oil at oil filler (2). 10. After refilling with oil, start the engine and idle it for a while. Inspect for oil leaks at the filter and drain plug. Then stop the engine and check the oil level. Wait for five minutes before checking. 3-47 WA420-3MC