MAINTENANCE 24.8.2 REPLACE TRANSMISSION OIL FILTER ELEMENT 1. Remove drain plug (1) at the bottom of the filter case, and drain the oil. After draining the oil, reinstall and tighten the plug. Drain plug . . . . . . . . . . . . 108 ± 15 N 2. Hold case (2) and loosen center bolt (3), then remove case (2). Obtain a genuine Komatsu filter element. Replace the filter gasket and O-rings with new parts. Coat the gasket and O- rings with clean engine oil before installing. 3. Remove the element, and clean the inside of the case. Assemble a new element, then install the case.
Before tightening center bolt (3), install bolt washer (4) so that its chamfered surface faces the hexagonal head of the center bolt. Be careful not to apply excessive torque to center bolt (3). Center bolt . . . . . . . . . . . . . 76 ± 12 N 4. Run the engine for a short time at idle, then turn the engine off and check that the oil is at the specified level. For details see “24.2.2 CHECK TRANSMISSION OIL LEVEL, ADD OIL” on page 3-32 . 3-54 WA420-3MC