WARNING: For reasons of safety, always follow these safety precautions. SAFETY 7.3 TRANSPORTATION Loading and unloading the machine always involves potential hazards. EXTREME CAUTION SHOULD BE USED. When loading or unloading the machine, run the engine at low idling and travel at low speed. Perform loading and unloading on firm, level ground only. Maintain a safe distance from the edge of road. ALWAYS block the wheels of the hauling vehicle and support both ramps with blocks before loading and unloading. ALWAYS use ramps of adequate strength. Be sure the ramps are wide and long enough to provide a safe loading slope.
Be sure that the ramps are securely positioned and fastened, and that the two sides are at the same level. Be sure the ramp surface is clean and free of grease, oil, ice and loose materials. Remove dirt from the machine tires. Drive straight. NEVER correct steering on ramps. If necessary, drive away from the ramps and climb again. After loading, block the machine tires and secure the machine with tie-downs. Loading and unloading Tie-downs When shipping the machine on a hauling vehicle, obey all state and local laws governing the weight, width, and length of a load. Also obey all applicable traffic regulations.
Determine the shipping route while taking into account the width, height and weight of the load. Height, width, load of machine Before passing over bridges or structures on private land, first check that the structures will support the mass of the machine. When traveling on public roads, check with the relevant authorities for instructions. The machine can be dismantled for transportation; consult your Komatsu distributor for assistance. 1-18 WA420-3MC LOADING AND UNLOADING SHIPPING