Komatsu — 16.4 OTHER TROUBLE

16. TROUBLESHOOTING 16.4.4 APS (automatic priming system) ( ): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, please contact your Komatsu distributor for repairs.

2-119 Problem Main causes Remedy Engine does not start at all ‡ Clogged nozzle (dirt, precipitation of paraffin, defective nozzle) ‡ Defective glow plug ‡ Crushed, clogged fuel piping, fuel leakage ‡ Defective wiring ‡ Blown fuse ‡ Defective APS controller (‡ Clean, change to specified fuel, replace nozzle) (‡ Replace) (‡ Check, repair) (‡ Check, repair) (‡ Replace) (‡ Replace) Engine starts at once, but there is excessive white smoke or engine stops again ‡ Clogged nozzle (dirt, precipitation of paraffin, defective nozzle) ‡ Defective glow plug ‡ Blown fuse ‡ Defective alternator function (alternator output is too low) ‡ Defective APS water temperature sensor ‡ Defective APS controller (‡ Clean, change to specified fuel, replace nozzle) (‡ Replace) (‡ Replace) (‡ Check, repair or replace) (‡ Replace temperature sensor) (‡ Replace) When load is applied, black smoke comes out and engine stops ‡ Defective APS water temperature sensor ‡ Melting of heater relay contacts (‡ Replace temperature sensor) (‡ Replace heater relay) Preheating monitor lamp stays lighted up and burner burns Preheating monitor lamp does not light up (this is normal when engine water temperature is 20°C or above) ‡ Disconnection in preheating monitor, glow plug wiring ‡ Defective wiring ‡ Defective timer (‡ Replace) (‡ Check, repair) (‡ Replace) Burner does not burn ‡ Glow plug is not red hot ‡ See above “Preheating monitor lamp does not light up” ‡ Fuel is not being sprayed out from nozzle, or spray amount is too small fi Clogged nozzle (dirt, precipitation of paraffin, defective nozzle) fi Defective APS controller (fi Clean, change to specified fuel, replace nozzle) (fi Replace)