Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.17 BLEEDING AIR FROM HYDRAULIC TANK After replacing oil and filter element or cleaning strainer, bleed the air from the circuit. After changing the oil and replacing the element in the hydraulic tank, or when the hydraulic cylinder or work equipment piping has been removed, do as follows to bleed the air after comple- tion of assembly of the equipment. After bleeding air from piston pump, bleed air from hydraulic circuit. Bleeding air from piston pump NOTICE If the air is not bleed completely, the piston pump may be damaged, so always carry out the air bleeding operation correctly.

Before bleeding the air from the piston pump, check that the hydraulic tank is filled with oil up to the top of the sight gauge. (If the oil level is low, add oil.) 1. Loosen plug 1 on top of the tube at the suction side of the piston pump. There is one plug for each pump, so loosen all plugs (2 places). 2. Loosen the connector at block 3 side of case drain hose 2 of the piston pump. The case drain hoses (x 2) for each pump are connected to block 3 , but loosen only the connector of case drain hose 2 con- nected to the top of the block. There is no need to loosen the connectors of the other two case drain hoses. 3.

Continue until oil flows out from plug 1 (2 places) and the connector of hose 2 . After the air has been completely bled, tighten plug 1 (2 places) and the connector of hose 2 . 4. Check the oil level and add oil if necessary. For details, contact your Komatsu distributor. 3-40