Komatsu — 24.10 EVERY 4000 HOURS SERVICE

24. SERVICE PROCEDURE 24.10 EVERY 4000 HOURS SERVICE WARNING Be sure to put a warning tag on work equipment control levers 1 . Maintenance for every 50, 100, 250, 500, 1000 and 2000 hours should be carried out at the same time. 24.10.1 CHECK WATER PUMP Check that there is no play in the pulley, oil leakage, water leakage, or clogging of the drain hole. If any abnormality is found, please contact your Komatsu distributor for disassembly and repair or replacement. 24.10.2 CHECK ENGINE VIBRATION DAMPER Check decrease of damper fluid, dent or out-of-flat. If there is any abnormality, contact your Komatsu distributor for repair.

24.10.3 CHECK FAN PULLEY AND TENSION PULLEY Check the pulley to see if there is any leaking grease. If any abnormality is found, ask your Komatsu distributor to repair or replace it. 24.10.4 REPLACE INJECTION PUMP SCREEN FILTER Remove injection pump cap 1, then replace screen filter 2 with a new part. The side of the screen filter with the holes is assembled facing the inside. Tightening torque of cap 1 : 22.1 ± 2.5 N·m (2.25 ± 0.25 kgf·m, 16.3 ± 1.8 lbft) A w q AE134620 A – A A 24.10.5 CLEAN INJECTION PUMP OIL INLET STRAINER 1. Remove oil inlet strainer 1 , soak the whole strainter in diesel oil, then rinse it clean. Oil outlet 2.

Blow compressed air in through the oil discharge port at the tip of the strainer. Repeat Steps 1 and 2 two or three times to clean the strainer. Tightening torque of strainer 1 : 11.3 ± 1.5 N·m (1.15 ± 0.15 kgf·m, 18.3 ± 1.1 lbft) Oil inlet AE134630 3-83