Komatsu — 31.2 PRECAUTIONS WHEN HANDLING AUTO-GREASING SYSTEM

31. HANDLING AUTO-GREASING SYSTEM 8. Adjustment of greasing rate and injector Adjust the injector to change the greasing rate for 0 – 30 hours (First step), 30 – 150 hours (Second step) and after 150 hours after the auto-greasing system installed. For the first 30 hours of operation (first step), make the interval 11.25 minutes. Following the first 30 hours, make the interval 18.75 minutes. (When the machine is shipped from the factory, it is set to the first step.) The injector turns by 10 turns between the full minimum opening positions.

5-23 Up to 30Hr Up to 150Hr First step Second step 11.25 min 18.75 min cc/Hr Adjustment of injector cc/Hr Adjustment of injector cc/Hr 1 Bucket hinge (Right and left) 31.2 Open fully 15.6 Keep at position for first step. 7.8 Open two fully. for first step. 2 Bucket link (Front) 7.8 Open fully 3.9 Keep at position for first step 3.9 Keep at position for first step. 3 Bucket link (Rear) 7.8 Open fully 3.9 Keep at position for first step. 3.9 Keep at position for first step. 4 Bucket cylinder rod 7.8 Open fully 3.9 Keep at position for first step. 1.95 Close by 5 turns from full. 5 Bucket cylinder bottom 7.8 Open fully 3.9 Keep at position for first step. 1.95 Close by 5 turns from full.

6 Tilt lever (Center) 15.6 Open fully 7.8 Keep at position for first step. 3.9 Open one fully. Close one to minimum. 7 Boom cylinder rod (Right and left) 7.8 Open fully 3.9 Keep at position for first step. 1.95 Close by 5 turns from full. 8 Boom cylinder bottom (Right and left) 7.8 Open fully 3.9 Keep at position for first step. 1.95 Close by 5 turns from full. 9 Boom pivot (Right and left) 7.8 Open fully 15.6 Keep at position for first step. 3.9 Keep at position for first step. 0 Center hinge pin (Upper) 7.8 Open fully 3.9 Keep at position for first step. 1.95 Close by 5 turns from full. A Steering cylinder bottom (Right and left) 7.8 Open fully 3.9 Keep at position for first step.

1.95 Close by 5 turns from full. B Center support 7.8 Open fully 3.9 Keep at position for first step. 1.95 Close by 5 turns from full. C Center hinge pin (Lower) 7.8 Open fully 3.9 Keep at position for first step. 1.95 Close by 5 turns from full. D Rear axle support (Front) 15.6 Open fully 7.8 Keep at position for first step. 3.9 Open one fully. Close one to minimum. E Transmission mount support 7.8 Open fully 3.9 Keep at position for first step. 1.56 Close by 6 turns from full. F Rear axle support (Cover) 15.6 Open fully 7.8 Keep at position for first step. 3.9 Open one fully. Close one to minimum. G Rear axle support (Top) 15.6 Open fully 7.8 Keep at position for first step.

3.9 Open one fully. Close one to minimum. H Steering cylinder rod (Right and left) 7.8 Open fully 3.9 Keep at position for first step. 1.95 Close by 5 turns from full.