Komatsu — 11.2 SWITCHES

11. EXPLANATION OF COMPONENTS 15. PREHEATER SWITCH (APS (automatic priming system) switch) When using APS, engine intake air is heated. Usually, the switch should be in the OFF position. a OFF position: The pre-heat function is not working. b AUTO position: When engine water temperature is below 13˚C, APS starts. After starting, maintain this position until the lamp of the afterheating monitor goes out. Before starting APS, put the switch to ON and then put it to this position. c ON position: If the switch is moved again from AUTO position and upward to ON, APS operation will begin. If the switch is released when at the ON position, it will automati- cally return to AUTO.

When the engine settle down after starting, put the preheater switch in OFF position. Method of using preheater switch, refer to the section “12.2.2 STARTING IN COLD WEATHER”. 16. FUEL CUT-OFF SWITCH Engine fuel consumption will be cut. When using APS (automatic priming system) in cold weather, use when starting. a OFF: Fuel is not supplied to the engine. b ON: Fuel is supplied to the engine. When hand is removed from OFF position, switch returns to ON position. For detailed method of usage, refer to “12.2.2 STARTING IN COLD WEATHER”. 2-20