11. EXPLANATION OF COMPONENTS 11.5.2 METHOD OF OPENING AND CLOSING CAP WITH LOCK (For the hydraulic tank filler port) (IF EQUIPPED) TO OPEN THE CAP 1. Insert the key into the cap. Insert the key as far as it will go. If the key is turned before it is inserted all the way, it may break. 2. Turn the key counterclockwise and bring the rotor groove in line with the aligning mark on the cap. Turn the cap slowly until a “clicking” sound is made. This releases the lock and allows the cap to be opened. TO LOCK THE CAP 1. Turn the cap into place. 2. Turn the key clockwise and take the key out.
11.6 ENGINE EMERGENCY STOP SWITCH AND FUEL STOP LEVER WARNING Never use these when stopping the engine normally. After using them, return the switch to the normal position and the fuel stop lever to the fully open position when the engine has stopped completely. Use these if any abnormality occurs and the engine does not stop even when the starting switch is turned to the OFF position. For normal operations, keep engine emergency stop switch B at normal position a and fuel stop lever A at the fully open position. If any abnormality occurs, operate engine emergency stop switch B to the emergency stop position b or turn fuel stop lever A to the front to stop the supply of fuel.
If any abnormality occurs which needs the fuel stop lever to be used, please contact your Komatsu distributor. If the engine is stopped using the fuel stop lever, bleed the air from the circuit before starting the engine again. For details, see “24.7.1 REPLACE FUEL FILTER CARTRIDGE.” 11.7 SAFETY BAR WARNING Always use the safety bar for maintenance or when trans- porting the machine. Always remove the safety bar during normal travel opera- tions. The safety bar is used during maintenance or when transporting the machine. It locks the front frame and rear frame, and prevents the front and rear frames from bending. 2-29