11. EXPLANATION OF COMPONENTS 4. TEMPERATURE CONTROL SWITCH The temperature can be adjusted steplessly from low tempera- ture to high temperature. The temperature level indicator lamps light up to display the temperature of the air coming from the vents. The more the blue lamps light up, the lower the temperature is. The color of the indicator lamp changes while the switch is being pressed. When the temperature reaches the desired level, release the switch to set the temperature. The settings for each mode are retained in memory even when the starting switch is turned OFF. However, in the following cases, the settings must be made again.
When the machine has been out of use for more than 7 days When the battery voltage is extremely low When there has been abnormal interference from outside If the car heater is used at the FRESH position, the inside of the cab will be pressurized and this will prevent the entry of dust. The higher the position of the fan switch, the more effective the pressurizing becomes. 11.20.2 METHOD OF OPERATION When carrying out the defrosting, if the temperature control switch is set so that all lamps are red, this will improve the perform- ance for defrosting and demisting. Set the vent mode selector switch to the intermediate position to give the desired condition.
With the FACE vents, it is possible to adjust the direction of the air flow and to turn it on or off. However, do not set to the FACE mode with the vents closed. 2-49 Switch Condition of use Fan switch Temperature control switch FRESH/RECIRC switch Vent mode selector switch Heating Rapid HI All red RECIRC FOOT Normal HI-LO More than half are red FRESH FOOT Defroster HI More than half are red FRESH DEF Ventilation or pressurizing HI-LO All blue FRESH FACE