Section E - Hydraulics Circuit Descriptions Straight Line Travel Straight Line Travel For individual travel and boom circuits, K Fig 9. ( T E-33) . To demonstrate the linear travel, both travel spools and boom up spool have been selected, refer to individual circuits. Servo pressure enters the main control valve 14 at Pa1 to select LH travel spool. This pressure is seen at the travel pressure switch 51 and also selects the linear travel (1) spool (LT1) Servo pressure enters main control valve 14 at Pa6 to select RH travel spool.
The pressure is also seen at the travel pressure switch 51 and also passes through the selected LT1 spool to select linear travel (2) spool (LT2) Servo pressure has entered the main control valve 14 at Pa8 to select the boom up spool. This pressure is also seen at the upper pressure switch 52 and passes through LT2 to select liner travel spool (3) (LT3) Oil from pump 1 enters the main control valve 14 at port P2 and is used at the boom 1 spool. This also passes over the selected LT3 spool to supply the boom 2 spool. The oil from both boom spools 1 and 2 merges and exits the main control valve 14 at A8 to raise the boom.
Oil from pump 2 enters the main control valve 14 at port P1 and is available at the LH travel spool and the RH travel spool via LT3. E-32 E-32 9803/9880-3