JCB — 97.pdf (p.97)

Section E - Hydraulics Slew Motor Slew Brake Operation Slew Brake Operation Cylinder block F is splined to output shaft G . Two friction plates A are splined to the outer edge of the cylinder block and are interleaved between three counter plates B which are fixed to the slew motor casing E . locking cylinder block F and casing E and preventing rotation. The brakes are released when hydraulic pressure is applied to port X . Oil enters chamber Y and pushes brake piston D up, against the pressure of spring C , to release the previously locked friction plates A and counter plates B . Cylinder block F is now free to rotate within casing E .

The brakes are applied when the hydraulic pressure at port X is zero. Spring C pressure forces piston D down to press the friction plates and the counter plates together, thereby C D E F G A Y X B C075120 Fig 2. E-134 E-134 9803/9880-3