honda — BF75A/BF90A

6. BF75NBF90A INSTALLATION HEIGHT RECOMMENDATIONS TRANSOM DRILL FIXTURE Shaft Length Out board Workable Boat Transom Height Transom Height @ D C B 0 D C TRA N S 0 M D RI L LI N G See also “USING THE TRANSOM MOUNT DRILL FIXTURE” on page 1-23. Use the upper and lower holes. Description Part No. 2. Mark four center marks for the bolt holes on the transom board (two marks on either side of the outboard motor installation lines). The upper bolt holes should be more than 33 mm (1.3 in) from the top of the transom. The lower bolt holes should allow the mounting bolts to contact the upper end of the stern bracket.

4 90” Transom Mount Drill Fixture 07MPZ-ZV301 OC The BF75A and BF9OA outboards motors are designed to be installed on a boat transom with the following transom board thickness: I Boat Transom Board Thickness 1 I 50 - 70 mm (2 - 2.75 in) ~~ 1 1. Set the outboard motor onto the boat transom and verify the installation height is correct. I 251 ;i I n = N Unit: mm (in) e X 0 ? Lo= c) = In TRANSOM TOARD TOP Ing 3. Drill four holes with a 17/32 drill bit. 0 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 615