honda — BF75A/BF90A

6. BF75NBF90A TILLER HANDLE ASSEMBLY INSTALLATION SCREW, 5 x 12 rnrn METER WIRE HARNESS A POWER TRlMRlLT MOTOR WIRE TRIM ANGLE SENSOR WIRE 1. Remove right side cap from tilt tube. FRICTION SHAFT FRICTION BLOCK FRICTION BOLT COTTER PIN 2. Apply marine grease to the friction shaft and install friction shaft into tilt tube. Apply marine grease to O-ring then install 0- ring into friction block. Install friction block over friction shaft and onto tilt tube. Install the friction bolt, 6 mm nut, and cotter pin on the friction block. shown. After connecting the connectors, HARNESS BAND METER WIRE HARNESS A Make a U-shape turn as clamp them with the harness band as shown. 3.

Connect Meter Wire Harness A to the tiller handle wire harness. Remove tiller handle cover, and connect Meter Wire Harness A to tiller handle harness. Connect harnesses as shown and secure with harness bands and harness clips. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 618