honda — BF115A/BF130A

7. BF115AIBF130A INSTALLATION HEIGHT RECOMMENDATIONS TRANSOM DRILL FIXTURE Shaft I Outboard I WorkableBoat I Length I Transom Height I Transom Height I @ D C B B 0 TRANSOM DRILLING See also ‘USING THE TRANSOM MOUNT DRILL FIXTURE” on page 1-23. I Description I PartNo. I Use the upper and lower holes. I Transom Mount Drill Fixture I 07MPZ-ZV3010C I 2. Mark four center marks for the bolt holes on the transom board (two marks on either side of the outboard motor installation lines). The upper bolt holes should be more than 33 mm (1.3 in) from the top of the transom. The lower bolt holes should allow the mounting bolts to contact the upper end of the stem bracket.

The BF115A and BF130A outboards motors are designed to be installed on a boat transom with the following transom board thickness: Boat Transom Board Thickness 50 - 70 mm (2 - 2.75 in) 1. Set the outboard motor onto the boat transom and verify the installation height is correct. Unit: mm (in) d X Fi - k L“= In TRANSOM BOARD TOP 0 Be 3. Drill four holes using a 17/32 drill bit. 7-7 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.