honda — Gauges

9. GAUGES Water Pressure Gauge (not included in 5 gauge set) Ref 1 Qty. Description 1 Water Pressure Gauge Mounting Bracket RubberHose 14 2 1 3 1 P I I I 2 1 BrassNut I 5 I 2 I Splitwasher I a 0 l 1 . I 1 I 1/8" NPT Fitting 171 1 I Red Sleeve I 8 9 2 CableTie 118" BSPT (British Pipe Thread- 118" NPTF (National Pipe Thread- 1 male) female) AdaDtor 1/8" NPTF To BSPT Analog Hour Meter (not included in 5 gauge set) Ref Qty Description 1 Volt Meter 1 Mounting Bracket 2 Brass Nut 2 Splitwasher 1 Red Sleeve 1 2 3 4 5 321 03-ZW7-000AH) to connect Faria gauges to the Honda main harness GAUGE INSTALLATION 1. Disconnect the battery negative terminal. ~ _ _ _ _ GAUGE-- HOLE DIA. 2.

Select a mounting location for the appropriate gauge@) which provides easy readability from the operator's position. Check behind each mounting hole location for sufficient installation clearance. 3. Cut a hole in the dash for each gauge to the specification shown. Speedometer Tachometer 86 mrn (3-318") 86 mm (3-318") Trim Meter Volt Meter 52.4 mm (2-1116") Fuel Gauge 52.4 rnrn (2-1/16") 52.4 mrn (2-1116") Water Pressure Hour Meter I 52.4 rnrn (2-1116") I 52.4 rnm (2-1/16") 4. Install the gauge in its mounting hole and check the fit. If necessary, install the red cover over the light bulb before installing the gauges: LIGHT SOCKET a.

Twist the black socket assembly one-eighth turn counterclockwise and remove it. b. Pull the bulb straight out of the assembly. RED SLEEVE c. Slip the red sleeve over the bulb and install socket assembly. 4. Mount the gauges with mounting brackets, split washers and brass nuts as shown starting on the next page. Tighten the nuts until the gauge can no longer be rotated in the dash. Do not overtighten the mounting nuts. Overtightening the nuts June crack the gauge housing, mounting bracket or mounting panel. 9-1 I Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.