9. GAUGES WATER PRESSURE GAUGE RUBBER HOSE INSTALLATION 1. After installing the speedometer in the dash, connect the rubber hose to the back of the speedometer and secure with a cable tie. 2. Route the rubber hose back to the motor alongside the control cables. A slight downward slope from bow to stern will help avoid trapping water. Avoid sharp turns, crimping, kinking, or other forces that June reduce the inside diameter of the hose. Do not coil any excess rubber hose. Carefully measure, then cut to the desired length. BF75/90/115/130 1. Remove the grommet and make a hole a little larger than the rubber tubing. 2. Route the tubing through the grommet and reinstall the grommet. 3.
Remove the flush valve spacer. 4. Drill and tap the flush valve spacer raised bossed to 1/8" N PT. 5. Thoroughly clean the flush valve spacer then reinstall it. FLUSH VALVE SPACER BF115/130 FLUSH VALVE SPACER I I Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 9 4 8