honda — Gauges

9. GAUGES Water Pressure Gauge (not included in 5 gauge set) Ref 1 2 3 4 5 6 7 Qty. Description 1 Water Pressure Gauge 1 Mounting Bracket I RubberHose 2 BrassNut 2 Star Washer 1 1/8" NPT Fitting 1 RedSleeve 0 8 8 9 2 CableTie 118" BSPT (British Pipe Thread- 118" NPTF (National Pipe Thread- 1 male) female) AdaDtor 1/8" NPTF To BSPT Analog Hour Meter (not included in 5 gauge set) Ref 1 Qty Description 1 Volt Meter Mounting Bracket 4 2 BrassNut 0 Use the Beede Instrument Harness (P/N 32103-ZW7-000AH~ to connect Beede gauges to the Honda main harness (refer to 9-25). GAUGE INSTALLATION 1. Disconnect the negative battery terminal cable. 2.

Select a mounting location for the appropriate gauge(s) which provides easy readability from the operator's position. Check behind each mounting hole location for sufficient installation clearance. 3. Cut a hole in the dash for each gauge to the specification shown. Speedometer Tachometer Trim Meter 86 mm (3-3/8") 86 mm (3-3/87 52.4 mm (2-1/16") Volt Meter Fuel Gauge Water Pressure 52.4 mm (2-1/16") 52.4 mm (2-1/16") 52.4 mm (2-1/16") I ,- Hour Meter I 52.4 mm (2-1116") 4. Install the gauge in its mounting hole and check the fit. If necessary, install the red cover over the light bulb before installing the gauges: LIGHT SOCKET a.

Twist the black socket assembly one-eighth turn counterclockwise and remove it. b. Pull the bulb straight out of the assembly. c. Slip the red sleeve over the bulb and install socket assembly. 4. Mount the gauges with the appropriate mounting bracket, star washers and brass nuts as shown starting on the next page. Tighten the nuts until the gauge can no longer be rotated in the dash. If necessary, shorten the clamp legs if the dashboard thickness exceeds clamp grip range. Do not overtighten the mounting nuts. Overtightening the nuts June crack the gauge housing, mounting bracket or mounting panel. 9123 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.