9. GAUGES WATER PRESSURE GAUGE TUBING INSTALLATION 1. After installing the water pressure gauge in the dash, connect the rubber hose to the back of the water pressure gauge and secure with a cable tie. 2. Route the rubber hose back to the motor alongside the control cables. Avoid sharp turns, crimping, kinking, or other forces that June reduce the inside diameter of the hose. Do not coil any excess hose. Cut hose to the desired length. 3. Fasten the rubber hose at regular intervals with small plastic cable ties (be careful to not pinch the hose). NIPPLE BF7519011151130 GROMMET 1. Remove the grommet and make a hole a little larger than the rubber hose. 2.
Route the rubber hose through the grommet and reinstall the grommet. BF75/90 3. Remove the flush valve spacer. 4. Drill and tap the flush valve spacer raised bossed to 1/8" N PT. valve spacer then reinstall it. 5. Thoroughly clean the flush FLUSH VALVE SPACER BFll5/130 I1/8" NPT I Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 9130