9. GAUGES BF2001225 1. Use a 5 mm hex wrench and remove the water pressure access plug (located above the starboard exhaust manifold). ADAPTOR 118" NPTF TO BSPT* I 2. Apply sealing compound to the adaptor 1 /8 NPTF to BSPT (supplied with kit*) and install the adaptor securely where the access plug was removed. 3. Apply sealing compound to the 1 / 8 NPT brass hose fitting (supplied with kit) and install the fitting securely in the adaptor. 4. Use a 7/32" drill bit and open the hole through the grommet membrane. 118" NPT FITTING CABLE ?lE RUBBER HOSE 5. Route the rubber hose through the hole and to the hose fitting. 6. Attach the hose to the brass fitting and secure it with a cable tie. 7.
Use cable ties and secure the rubber hose to various spots on the motor making sure it does not come into contact with any moving parts or hot components. *Some water pressure gauge kits will not have the adaptor supplied. Do not use the 1/8" NPTF adaptor. Order P/N 19271-ZV5-000 BSPT 1 / 8 hose barb fitting. LIGHT BULB REPLACEMENT 1. Twist the black socket assembly one-eighth turn counterclockwise and remove it. 2. Pull the bulb straight out of the assembly. REPLACEMENT BULBS: GE161 3. If a red sleeve is covering the meter bulb, remove the RED SLEEVE red sleeve and install it on the new bulb before reinstalling the socket assembly. 4. Reinstall the socket assembly. T Date of Issue:
June 2003 0 2001-2003 American Honda Motor Co., Inc.