honda — Control Boxes and Templates

10. CONTROL BOXES AND TEMPLATES REMOTE CONTROL BOX LOCATION AND SELECTION LOCATION Select a mounting location which allows easy access and unobstructed, comfortable operation of the remote control lever. Make sure there are no cable obstructing components between the remote control box and the outboard motor. The remote control box is normally mounted on the starboard side of the gunnel. The control lever can be reversed to accommodate port side or starboard helmkonsole installation. CONTROL CABLE SELECTION/ROUTING 2. Determine and select the remote control cable length. Top mount control: - CABLE LENGTH: L1 + L2 + 300 mm (12 in) REMOTE CONTROL Dual mount remote control:

- Measure the control cable routing length to 1. Select a mounting location which permits easy access and unrestricted operation of the control lever. Make sure there are no other parts obstructing the cables or components between the remote control box and the outboard motor. The bottom of the remote control box should be at the same level as the upper surface of the seat. Top Mount Controls Insert a spacer between the box and the installation surface if the travel of the operating lever is compromised (see page 10-1 0). the respective outboard motors. If the cable is routed around one outboard motor to the other side: - CABLE LENGTH:

L1+ L2 + 1200 mm (48 in) The bending diameter of a cable must never be less than 400 mm (16 in). If the cable is routed in a tight arc, resistance on the control lever will increase, and a smooth throttle operation is no longer possible. This June lead to a loss of control over the craft. The cable length must be calculated in such a way that unrestricted operation is possible, even if the outboard motor@) are tilted or turned to one side. RECOMMENDED REMOTE CONTROL CABLES Description Part No. TFXTREME Accessories Catalog (SAE, 10-32 thread) (M0045). Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 1012