3. BFISDIBFZOD 1 , LOaPLATE(2) CONTROL \ SHIFT CONTR~L CABLE 4. Shift the outboard into forward gear by moving the shift link arm forward while turning the propeller. 5. Coat the pivots with marine grease. 6. Set the remote control lever full forward and adjust the shift pivot to be a slip fit in the shift link arm. Slide the lock plate down to secure the Divot. a. Operate the remote control and check to see that: When the remote is at full throttle (WOT), the throttle is within 1 mm of the stop. When the remote is at full throttle (WOT), the shift linkage is in the forward detent. When the remote is in neutral, the throttle is against the idle stop screw.
When the remote is in neutral, the shift linkage is in the neutral detent. When the remote is in reverse, the shift linkage is in the reverse detent. (Turn the prop while shifting gears.) 7. With the remote control lever still full forward, hold the throttle remote arm against the full throttle stop and adjust the throttle pivot to be a slip fit in the throttle remote arm. Slide the lock plate up to secure the pivot. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 311 2