honda — BF25A/BF30A

4. BF25AIBF30A STEERING CONNECTIONS Do this before final placement of the motor on the transom. Refer to the steering cable manufacturer’s manual for cable handling procedures. -.- STEERING CABLE \ STEERING LINK P SELF-LOCKING NUT (4) STEERING LINK ARM w SEALED Tilt-Tube Type - CAP 4 STEERING CABLE STEERI~G~TILT TUBE STEERING CABLE NUT 1. Remove the left and right caps from the steeringhlt tube. 2. Apply marine grease to the steering cable and install the steering cable through the steeringhlt tube. Do this before final placement of the motor on the transom. 3. Position the motor on the center line. If 5. Install the sealed cap on the steeringhilt tube.

Below is a list of two optional steering tube seals which are available and include a grease fitting. Description Part No. applicable, line up the drilled holes in the I Stainless steel I 50899-ZV5-020AH transom with the-holes in the stern bracket. Tighten the clamp screws. 4. Hand tighten the steering cable nut at this time. I Anodized aluminum I 50899-ZV5-000AH Date of issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 4ma