5. BF40NBF50A DETENT ROLLER \A /- SHIFT LINK B 4. If not, loosen the lock nut and adjusting nut connecting shift rod A to shift rod B. 5. Disconnect shift rod A from shift rod B by backing off the adjusting nut. Back off the adjusting nut until it is approximately 3 mm above the top of shift rod B. 6. Turn the lock nut on shift rod B to obtain 0.3 inch (8 mm) between the lock nut and the top of shift rod B as shown. 7. Thread the adjusting nut onto shift rod B until the adjusting nut comes in contact with the lock nut. When the adjusting nut contacts the lock nut, tighten the lock nut and adjusting nut together. 8. Reconnect the shift control cable to the shift arm. 9.
Put the remote control lever in the neutral position. 10. Verify the detent roller sits in the N groove of the shift link B. 11. If not, loosen the shift control cable lock nut, disconnect the shift control cable and turn the pivot shaft until the adjustment is correct. 12. After the adjustment, reconnect the shift control cable and tighten the lock nut securely. 13. Verify the remote control lever moves smoothly into all positions. Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc. 511 4