K ENWORTH T680 MIRRORS - SERVICE MANUAL Right hand bezel opening 6.3.2. Heaters wires Socket Plate Slot Routing: 1. Guide both sets of heater wires through the opening located on the right side of the bezel (shown above). 2. Guide the convex heater wires through the slot located on the adjustable socket plate. Insert all four connectors onto the heater foil terminals. Note: The convex heater wires contain two sets of wires leading into the connector. The main heater wires branch off of the convex heater wires. Copyright © Lang Mekra North America 2014 Page 15 of 28 Revised: 03/2014