K ENWORTH T680 MIRRORS - SERVICE MANUAL 6.4.3. Connector installation Removal: 1. To remove the connector, pull down on the connector to slide it out of the slot. See below. 2. The connector sits quite tight and one needs to pull and wiggle the connector in a downward direction until it slides out of the slot. Warning : Using a lever between the holder and the top of the connector to slide it down can damage the wires, connector and connector housing. Installation: 1. Attach the electrical connector onto the connector housing. 2. Slide the connector into the slot provided on the connector housing while pushing the extra cable into the arm. 3.
Slide the connector until it is locked into place. Copyright © Lang Mekra North America 2014 Page 19 of 28 Revised: 03/2014