N38143 Chapter 5 Belt drives - 4GM and 4TGM only. Standard options are:- Fenner 5” A section pulley with three grooves (A1) and taper lock (A2). or A Fenner 5” B section pulley with two grooves (A3) and taper locks (A4). In this case the maximum power which can be taken will be limited by the belts, and it will be necessary to calculate for marginal applications. Caution: Additional inertia must not be added to the P.T.O. shaft without specialist advice. Consult your distributor if you need advice about non-standard drive arrangements. Page 37