N38143 Chapter 6 L Series electronic governor guidelines A pinout of the L Series governor, as viewed into the control connector, is shown below (G). This information derived from document 5198-1-05. Note: If any features are not required in the application, the related wiring may be omitted.
Page 55 Connector pin# Description Comment 1 +12/24 VDC input power Supply power 2 TPS signal output Direct position feedback output indication 3 AUX - (sig gnd) Ground for AUX inputs 4 Aux input 3 / RS-232 transmit Combination Aux 3 and service tool input 5 Input power ground Ground for the 12/24V input power 6 Aux input 4 / RS-232 receive Combination Aux 4 and service tool input 7 5V out Power for external sensors (10mA max) 8 Aux input 1 Aux 1 input 9 Relay driver output Status / fault detection output 10 Aux input 2 Aux 2 input 11 MPU + MPU speed signal input 12 Ignition input Ignition speed signal input